Summer Prodigy - Page 25

Once the angle is
correct the word
“Tighten” will
automatically light up
on the Smart Screen.
Tighten the installa-
tion by rotating the
Belt Tightening Handle
to the left until a
appears.
The word “Complete”
will light up letting you
know that the
installation is complete.
ALWAYS check
for a secure installation.
If the base moves more
than one inch side-to-
side at the belt path,
repeat the above steps.
The word “Level” will
light up, indicating that
you need to adjust the
base angle.
Press the Recline
Adjustment Buttons on
both sides of the
Control Panel while
lifting or lowering the
base until a appears.
Ideally the “level to
ground” line on the side
of the base should be
level to the ground.
49
Base Installation
48
Base Installation
9
10
11
rotate!
press!press!
CARRIER IS INS
T
ALLED
IN
VEHICLE
WITH
THE BASE.
LATCH
STORAGE
LINE MUST BE LEVEL
WITH GROUND
WHEN
21110-L22
CARRIER IS INS
TALLED IN
VEHICLE WITH THE BASE.
LATCH
STORAGE
LINE MUST BE LEVEL WITH GROUND
WHEN
21110-L22
less
than
1”
press!press!
NOTE: If needed, a
pool noodle or a
tightly rolled towel
may be used under
the Recline Adjust-
ment Foot to
correctly adjust the
angle of the base.
The foot MUST be
on the lowest
position (#1).