Summer Prodigy - Page 26

Carrier
Attachement
to Base
Align Carrier with
Base and push firmly
into Base until you hear
a “Click!”.
Check the
connection is secure by
pulling up on the
Carrier in the front and
back.
Removing
Carrier from
Base
Firmly squeeze the
Carrier Release Handle
on the back of the
Carrier.
1
2
1
Checklist
Base Installation
51
click!click!
WARNING:
To prevent ejection, carrier must be secured
to base. Lift to check that carrier is secured.
CLICK!
CHECK!
squeeze!
squeeze!
check! check!
Base Installation
50
Check that the seat belt is secure,
untwisted, and routed correctly.
Check that the base angle is correct when
parked on a level surface:
1. Check that the Smart Screen shows a
under “Level”, AND
2. Check that the level to ground line
on the side of the Base is level to
the ground.
Check that the Base is securely fastened
to the vehicle.
Check that the base cannot move more than
one inch side-to-side at the belt path.
If the Base is not secure, repeat the installa-
tion making sure that the seat belt is pulled
snug before rotating the Belt Tightening
Handle.
REMEMBER! Use the “TEST” button
on the Control Panel to check your
installation approximately 30 days
from now, or as needed.
click!click!