MPE-200 Guide to Operations Page 15
5.3 MASTER PRESET screen (amber)
Channel B is the active channel, preset 6 selected
and unlocked, with preset 25 waiting to be loaded;
preset 8 is the previous preset for Channel B.
There are 25 user presets which store all settings and controls
except input setup and the output fader. Each channel has a preset,
whose number is shown on the top row of the Preset screen, along
with the lock status. Select a preset by turning the knob, and load it
by pressing the knob. A flashing arrow will always show the
pending preset selection.
If the preset selected is the same number as the current preset, the
pending preset number changes to the last previously loaded one.
Thus, by repeatedly pressing the knob, you can alternate between
any two presets, for “A-B” comparison.
If the MPE-200 is set to Stereo mode, a single preset is loaded
simultaneously for both channels, as shown on the preset page.
You can also manually select the same preset for both channels
while the MPE-200 is in 2-channel mode. In this state, all the
controls will operate as if in stereo mode, but changing presets is a
bit cumbersome. When changing from Stereo mode to 2-channel
mode, the MPE-200 will enter this state.
[
*
]
Any changes made to the settings while an unlocked
preset is selected will be automatically stored. Any
changes made to a locked preset will be lost when another
preset is loaded or when the MPE-200 is turned off.
See the next section for details on locking and unlocking presets.
4 6
↑ 25
1 8
To Next Page
Loading...