MPE-200 Guide to Operations Page 21
8.2 VOLTAGE SELECTION
Changing the supply voltage requires some
mechanical dexterity. If you have any doubt
about your mechanical abilities, please contact
your Summit dealer for assistance.
1) Using a long-nose pliers, gently pull the voltage selector
tab out of the right end of the Power Entry module.
2) Carefully move the white plastic key around the side of the
selector tab, until it faces AWAY from the desired voltage
legend printed on the tab.
3) Push the plastic key gently into the locating notch in the
edge of the tab. Double check that the voltage printed on
the edge of the tab away from the key is the one you want.
4) Carefully insert the selector tab back into the slot at the
right side of the Power Entry module, with the white plastic
key facing away from the MPE and the printed voltage
legend on the side of the tab toward the fuse holder. Firmly
push the tab into the slot until it seats.
5) Install the correct value fuse for the voltage you have
chosen. See section 8.1 for these values. Replace the fuse
holder and gently press it until it clicks.
6) Inspect the white dot which shows through the fuse holder
and confirm that the voltage setting is what you want.
9. REGISTRATION
Thank you for purchasing the MPE-200. Please fill out and return
the enclosed warranty card. When you register the unit, Summit
Audio will better be able to notify you of manual, firmware, and
MIDI upgrades. This unit must be registered for the extended three
year warranty to be in effect.
Please do not hesitate to phone, fax or e-mail Summit Audio with
any questions or comments. Many thanks from the Element 78
group of Summit Audio.
To Next Page
Loading...