MPE-200 Guide to Operations Page 7
SYSTEM OVERVIEW (ctd)
2.2 The MPE-200 has six control modules which are labeled on
the front panel. The outer two modules control Input
functions (mic gain, HP/LP filters, and setup) on the left, and
Master functions (gain trim, presets, setup and fader) on the
right. The four remaining modules control each of the four
equalizer bands, which are post mic preamp. The EQ may be
used separately from the mic preamps which have their own
outputs.
2.3 The MPE-200 uses two types of controls: Displays Switches
and Encoders. In general, pressing the display switch changes
the screen to a new mode. Turning the encoder changes the
parameter, and pressing the encoder knob selects the
parameter associated with that encoder. The display screen
backlight color is used to convey status for each module, but
this information is also contained in the screen contents, to
accommodate users whose color perception is impaired.
To Next Page
Loading...