Summit SP - PUMP SAFETY WARNINGS

Installation, Operation, and Maintenance Manual
SUMMIT PUMP MODEL SP 2
PUMP SAFETY WARNINGS
The safety information below should be followed and observed to prevent damage to
equipment or injury to operators:
WARNING!
Do not apply heat to the impeller inlet eye
or hub to remove impeller. The impeller
may fracture resulting in damage to
equipment or personal injury.
WARNING!
Do not operate pump with very low flow rate
or no flow rate. Overheating of the pump
and vaporization of pumping fluids may
generate extreme pressures. This may
result in damage to equipment or personal
injury.
WARNING!
Observe drive rotation prior to installing
couplings or drive belts. Failure to do so
may result in damage to equipment or
personal injury.
CAUTION!
Treat Summit SP pumps as both a pressure
vessel and rotating machinery. Follow all
safety instructions for both types of
equipment at all times.
CAUTION!
Feeding very hot or very cold fluids into the
pump at room temperature may result in
fracture of pump wet end.
CAUTION!
Follow all auxiliary equipment (motors,
drives, couplings ect) manufactures
manuals, instructions or procedures during
installation, operation and maintenance of
the pump.