Summit SP - MAINTENANCE AND REPAIR; ASSEMBLY PROCEDURES

Installation, Operation, and Maintenance Manual
SUMMIT PUMP MODEL SP 12
APPENDIX B – MAINTENANCE AND REPAIR
WARNING!
WEAR EYE PROTECTION. Failure to do
so can result in serious personal injury.
WARNING!
Pump parts are heavy. Use proper lifting
methods to avoid personal injury.
ASSEMBLY PROCEDURES
(See APPENDIX D for Cross-Section)
Fig 1.
1. Lightly grease or oil the bearing shoulders on Shaft(2.1). (See Fig 1)
2. Slide on a Grease Retainer(2.2) up to Shaft(2.1) shoulder. (See Fig 1)
3. Using induction heater preheat, bearing cone of Bearing(2.14) to 210°F.
4. Place cone of Bearing(2.14) positioned so the smaller diameter is positioned
outward from the center of Shaft(2.1) and install the Bearing Cone up to Grease
Retainer(2.2). (See Fig 1)
5. Install second Grease Retainer(2.2) and Bearing Cone(2.14) in opposite direction
and on opposite end of Shaft(2.1) repeating steps 2-4.