What to do if Sun-Mar Toilets drum is too full?
If the drum of your Sun-Mar toilet is too full, it might be because the compost wasn't emptied into the finishing drawer promptly, or kitchen/garden waste was added. Remove compost until the drum is half full or less. Rotate compost thoroughly to aerate, and add compost accelerant (Compost Quick and Microbe Mix) if available. It's also recommended to avoid adding kitchen or garden scraps.
Why is waste not breaking down in my Sun-Mar Toilets?
If waste isn't breaking down in your Sun-Mar toilet, causing the drum to fill up quickly, it could be due to insufficient moisture in the compost, insufficient microbes, or the room temperature being too low. Try adding water to the bio-drum, introducing Sun-Mar Microbe Mix, and ensuring the room temperature is constantly above 55°F/13°C.
How to eliminate flies in Sun-Mar Toilets?
To eliminate flies in your Sun-Mar toilet, you can use any pesticide that is used on your garden, as these are safe for your compost because they aren't anti-bacterial. Alternatively, you can completely clean out the toilet and wash the inside with soap and water.
What to do if compost is too wet in Sun-Mar Toilets?
If the compost in your Sun-Mar toilet is too wet, it may be due to poor compost porosity or a clogged drum screen. Change the bulking material to Compost Sure Blue. You can also spray the drum screen with Compost Quick and scrub it with a wire brush.
What to do if there are large lumps in compost in Sun-Mar Toilets?
If you find large lumps in the compost of your Sun-Mar toilet, it's likely that the compost is too dry. Add 1/2 to 1 gallon of warm water to the compost to reach the appropriate moisture level. Remove or break apart any lumps you find.
Why is the compost in my Sun-Mar Plumbing Product too wet?
If your Sun-Mar Plumbing Product's compost is too wet, it could be due to poor compost porosity, often caused by using too much peat moss. This compacts the compost, prevents drainage, and reduces airflow. Immediately improve porosity by adding about 1/2 gallon (2 liters) of wood shavings (not anti-bacterial). For ongoing maintenance, switch to Compost Sure Blue or 100% wood shavings as your bulking material.
How to get rid of flies in my Sun-Mar Plumbing Product?
If flies are present in your Sun-Mar Plumbing Product, it may be because the compost is too dry. Keep the compost moist. To determine the correct moisture level, shine a flashlight into the drum; the compost should have a slight gloss or shine. Another reason may be that the compost is anaerobic. If the compost smells, refer to 'Compost Remediation'. Anaerobic compost will attract flies and reduce the performance of your composting unit.
Why is the compost in my Sun-Mar Plumbing Product too dry?
If the compost in your Sun-Mar Plumbing Product is too dry, it could be due to several reasons. It may be that moisture isn't being added periodically, especially in cottage units, or the toilet isn't being used for urination. Insufficient microbes or a room temperature below 60F/15C can also cause dryness. Insufficient bulking material or not enough peat moss may also be the cause. Add 1/2 to 1 gallon (2-4 liters) of warm water to bring it up to the appropriate moisture level. Add Sun-Mar Microbe Mix. Install a heat source to increase the temperature above 55-60F/15C if the toilet is used regularly. Use the toilet for urination and add the correct bulking material.
How to handle effluent from my Sun-Mar Plumbing Product?
To handle effluent from your Sun-Mar Plumbing Product, you can use a container that is emptied periodically, such as a water jug or small barrel, to ensure a closed-loop system. Alternatively, you can feed the effluent into a lined pit filled with gravel and sand, creating a recycling bed that also ensures a closed-loop system. Other options include feeding it into a small cesspit or 'french drain', or plumbing it into an existing septic or holding tank line, following local regulations.
What to do if the vent stack of my Sun-Mar Plumbing Product has too many bends?
If the 2” vent stack of your Sun-Mar Plumbing Product has too many bends or horizontal lengths, re-install the vent stack to reduce the number of bends or eliminate horizontal lengths. You can also install fresh air intakes on any competing appliances. To check ventilation, hold a lighter up to the air intake holes on the back of the unit; air should be drawn in. If not, check the venting and provide more ventilation to the room. Install the vent with minimal bends (total bends should equal no more than 360 degrees) and NO horizontal or downward slopes.
Explains the overall process of composting toilets and their three-chamber design.
Details the function and operation of the primary composting chamber, including mixing and aeration.
Describes the secondary chamber where compost is isolated to finish composting.
Explains the chamber where excess liquid evaporates into water vapor.
Provides guidance on operating the unit during cold weather and preventing freezing.
Procedure for checking the unit for damage upon delivery before signing shipping papers.
Verifying included parts and performing initial operational checks on the unit.
Guidance on selecting an appropriate location for the composting unit, ensuring weather protection.
Provides key measurements for planning the installation space for the composting unit.
Lists all components provided with the composting unit for installation.
Step-by-step instructions for installing the toilet fixture to the unit.
Covers the assembly of the toilet's base and pedal mechanisms.
Guidelines for proper waste pipe installation, slope, and length.
Details the installation of the 3-inch waste inlet assembly for compost flow.
Instructions for connecting the unit's safety drains for liquid removal.
Options for managing the liquid produced by the composting process.
Advice on positioning the vent pipe to prevent odors and ensure proper airflow.
How to adjust the fan gate for optimal airflow and odor control.
Technical guidance for installing the vent piping system, including angles and material.
Instructions for safely routing the vent pipe through the roof with proper sealing.
Explains the function and installation of the vent pipe diffusor for improved updraft.
Recommendations for safe electrical connections, GFI protection, and wiring.
Steps for installing the 12-volt fan in the vent stack for improved ventilation.
Step-by-step guide for the initial setup and operation of the unit to establish composting.
Procedure for starting the unit at the beginning of a seasonal use period.
Regular checks to ensure optimal performance, moisture levels, and cleanliness.
Routine procedures for keeping the compost healthy, aerated, and moist.
Necessary conditions for aerobic bacteria to effectively break down waste: oxygen, moisture, carbon, warmth.
Explains the importance of proper moisture levels (40-60%) for composting activity.
Details how temperature affects composting activity, with slowing below 55-60 degrees F.
Lists signs of poor compost quality, such as lumps, muddy texture, or bad smells.
Addresses causes and solutions for urine odor issues, often related to vent pipe condensate.
Steps for troubleshooting a failed 110-volt fan, including replacement advice.
Discusses how an airtight room can affect unit performance and ventilation.
Addresses odor issues occurring outside the unit, often linked to vent stack installation.
Troubleshooting strong odors associated with drum rotation, usually due to anaerobic conditions.
Diagnosing and resolving noisy fan issues, including rattling or vibration.
Steps for diagnosing a non-functional fan, checking for debris or mechanical failure.
Addresses issues of excess liquid and poor evaporation, possibly due to usage or system failure.
Solutions for liquid overflowing from the drawer opening, often caused by blocked drains.
Troubleshooting steps for a non-functional heating system, checking thermostat and element.
Solutions for the drum not remaining in its upright position, often related to the drum locker.
Troubleshooting steps when the drum cannot be rotated, due to set screw or gear issues.
Resolving issues with the drum door's movement, often caused by caked compost.
Diagnosing and fixing problems with waste pipe blockage or gas bubbles.
Routine tasks performed every second day for unit upkeep, including adding compost mix.
Procedures for monthly checks, cleaning the drum screen, and emptying components.
Instructions for storing the unit during periods of no winter usage, focusing on preventing drying.
Guidance for using the unit intermittently during winter, treating it as a holding tank.
Recommendations for continuous winter operation, including vent pipe insulation and heat.
General| Brand | Sun-Mar |
|---|---|
| Model | CENTREX 2000 |
| Category | Plumbing Product |
| Language | English |
To Next Page
