iv Sun StorEdge 3000 Family FRU Installation Guide • May 2004
2.3.2 Converting a Tabletop Array to a Rack-Ready Array 2–14
3. Power and Fan Module FRUs 3–1
3.1 Replacing Power Supply/Fan Modules for 2U Arrays 3–2
3.1.1 Removing an AC Power Supply/Fan Module 3–2
3.1.2 Installing an AC Power Supply/Fan Module 3–3
3.1.3 Replacing a DC Power Supply/Fan Module 3–3
3.1.3.1 Removing a DC Power Supply/Fan Module 3–3
3.1.3.2 Installing a DC Power Supply/Fan Module 3–3
3.2 Replacing Power Supply/Fan Modules for 1U Arrays 3–5
3.2.1 Replacing an AC Power Supply/Fan Module 3–5
3.2.1.1 Removing an AC Power Supply/Fan Module 3–5
3.2.1.2 Installing an AC Power Supply/Fan Module 3–6
3.2.2 Replacing a DC Power Supply/Fan Module 3–6
3.2.2.1 Removing a DC Power Supply/Fan Module 3–6
3.2.2.2 Installing an DC Power Supply/Fan Module 3–7
4. Battery FRUs 4–1
4.1 Battery Operation 4–2
4.2 Battery Status on the Initial Firmware Screen 4–2
4.3 Battery Dating on the Battery Labels 4–3
4.4 Replacing a Battery 4–5
4.4.1 Replacing a SCSI Battery 4–5
4.4.2 Replacing an FC Battery 4–8
4.5 FC Battery Status and In-Service Date Procedures 4–10
4.5.1 Viewing Status and Setting the In-Service Date with the CLI 4–10
4.5.2 Viewing Status and Setting the In-Service Date with SSCS 4–11
4.5.3 Verifying the In-Service Date When Replacing a Battery in SSCS
4–13
To Next Page
Loading...
