5-8 Sun StorEdge 3000 Family FRU Installation Guide • May 2004
■ Scanning Status: Install Controller FRU. The installed controller is
performing self-test and scanning disk channels. This is also the state where
the controller will update the firmware on the newly installed controller if not
identical to the running firmware version. The controllers can remain in this
state for up to 10 minutes depending upon system activity.
■ Detected Status: Redundant Controller Process Starts. The installed controller
has completed the scanning of the disk channels, updated installed controller
firmware as required, and communicated to the primary controller. This status
is transitional and normally cannot be detected unless repetitive operations are
executed.
■ Enabled State: Redundant Controller Procedure Completed. The installed
controller has completed the redundant controller procedure enabling the
active-active operation.
5.1.5 SES Firmware Update Sometimes Required with
I/O Controller Module Replacements
Periodically, firmware upgrades are made available as patches that you can
download from SunSolve™ Online, located at:
http://sunsolve.sun.com
Sun StorEdge 3510 and 3511 FC array patches contain the most current version of the
controller, SES, and PLD firmware.
...
Redundancy status: Scanning
Secondary controller serial number: 0
...
Redundancy status: Detected
Secondary controller serial number: 0
...
Redundancy status: Enabled
Secondary controller serial number: 8006511
To Next Page
Loading...
Need help?
General
