40 Sun Fire V215 and V245 Servers Administration Guide • September 2006
system console settings, 15
OpenBoot emergency procedures
USB keyboard commands, 34
OpenBoot PROM prompt, 1
output-device (OpenBoot configuration
variable), 14, 15
P
parity, 13
patch panel, 8
patch panel, terminal server connection, 8
PCI, 7
PCI graphics card
configuring to access system console, 13
connecting graphics monitor to, 14
frame buffers, 13
R
reset-all (OpenBoot command), 14
RJ-45, 8, 9, 10
S
sc> commands
bootmode reset_nvram, 34
console, 35
reset, 35
sc> prompt
system console, switching between, 16
serial management port (SER MGT)
acceptable console device connections, 6
as default communication port on initial
startup, 4
default system console configuration, 5
SERIAL MGT, See serial management port
set-defaults (OpenBoot command), 35
setenv (OpenBoot command), 14
Solaris commands
tip, 9, 11
uname, 12
uname -r, 11
Stop-A (USB keyboard functionality), 34
Stop-D (USB keyboard functionality), 35
Stop-F (USB keyboard functionality), 35
Stop-N (USB keyboard functionality), 34
stress testing, See also exercising the system, 29
Sun Enterprise Authentication Mechanism
software, 30
superuser, 1
system console
accessing with alphanumeric terminal, 12
accessing with graphics monitor, 13
accessing with terminal server, 8
accessing with TIP connection, 9
accessing with tip connection, 9
alphanumeric terminal connection, 12
alternate configurations, 6
configuring local graphics monitor to access, 13
connection using graphics monitor, 7
default configuration explained, 4, 5
default connections, 5
defined, 4
graphics monitor connection, 7
setting OpenBoot configuration variables for, 15
system console sc> prompt, switching between, 16
system prompts, 1
T
terminal server
accessing system console from, 6, 8
connection through patch panel, 8
pinouts for crossover cable, 9
tip (Solaris command), 11
TIP connection
accessing system console, 9
accessing terminal server, 9
TTYA, 6
TTYB, 10
U
uname (Solaris command), 12
uname -r (Solaris command), 11