2 Book Title without trademarks, or an abbreviated book title • May 2008
■ “Handling Precautions” on page 2
■ “Secure Installation Requirements” on page 2
■ “Placement of a Sun Product” on page 3
Note – Do not make mechanical or electrical modifications to the equipment. Sun
Microsystems, Inc. is not responsible for regulatory compliance of a modified Sun
product.
Handling Precautions
Caution – A fully populated cabinet can weigh in excess of 1500 pounds (682 kg).
Ensure that all surfaces this system will move over can withstand this load.
The cabinet is equipped with wheels so you can move it. Use enough personnel
when moving the cabinet, especially on sloped loading docks and ramps, to gain
access to a raised computer room floor. Move the cabinet slowly and deliberately,
and make sure that the floor is free from foreign objects and cables that the cabinet
could roll over.
Caution – To avoid injury, wear protective footwear when moving a system.
Secure Installation Requirements
To minimize personnel injury in the event of a seismic occurrence, you must securely
fasten the cabinet to a rigid structure extending from the floor to the ceiling, or from
the walls, of the room in which the cabinet is located.
Install the cabinet on a level surface. At each corner, on the base of the cabinet, are
adjustable nonskid pads. Extend these pads when the cabinet is installed to prevent
the cabinet from rolling. Do not use these pads to level the cabinet.
To Next Page
Loading...
Need help?
General
