Shutdown 15
Shutdown
1 It is not necessary to wait for post-measurement processing to complete before disconnect-
ing MapCHECK 3. When measurement is complete, right-click Stop and select Stop and
Disconnect Device. This option is only available during post-measurement processing.
2 Disconnect power and data cable from MapCHECK 3, then remove from couch.
3 When post-measurement processing is complete, save files.
Contacting Sun Nuclear Support
You may request support in two ways:
• Contact the Sun Nuclear Support team by telephone: +1 321-259-6862.
• Submit a support request using our online form. See Support Website below.
Support Website
1 Open an internet browser and navigate to sunnuclear.com/support.
2 Enter your email address and the serial number of any Sun Nuclear device used at your
facility, then click Log in to open the Support Dashboard.
• To download product information, click Products and Downloads.
• To open a Support request, click Open A Support Case, complete the form, and then
click Submit.
Warranty
The Sun Nuclear Product Warranty can be found on the Sun Nuclear Support website.
To Next Page
Loading...