SUNBA P636 V2-Performance Series - Page 25

Select Leave Area and
then click .
Please leave it disabled.
- 24 -
Set the Trigger Actions and Plan as required.
Trigger Actions:
Send E-mail: this will send an email notification for the alarm along with a snapshot. For details, see
Chapter 3.3.
Upload Image(Original): this will send snapshots to FTP server once the alarm is triggered. For details,
see Chapter 3.4.
In the Detection Rule area,
click to add a new detection
area. Drag the borders of the
box to set the intended
position and range. You can
set the sensitivity and level
for the camera to decide
whether to trigger an alarm.
3
Leave Area
Leave Area detection detects objects that leave a specified area, and triggers alarm when such an
event is detected.
Set the Trigger Actions and Plan as required.
Trigger Actions:
Send E-mail: this will send an email notification for the alarm along with a snapshot. For details, see
Chapter 3.3.
Upload Image(Original): this will send snapshots to FTP server once the alarm is triggered. For details,
see Chapter 3.4.
Select Enter Area and
then click .
Please leave it disabled.
Set Detection Object type
and size.
2
1
3
Add a pre-designated view
as a home position preset,
please refer to Chapter 6.3
for detaills.
4
Click Save and then enable it.5
In the Detection Rule area,
click to add a new detection
area. Drag the borders of the
box to set the intended
position and range. You can
set the sensitivity and level
for the camera to decide
whether to trigger an alarm.
Set Detection Object type
and size.
2
1
3
Add a pre-designated view
as a home position preset,
please refer to Chapter 6.3
for detaills.
4
Click Save and then enable it.5