After continued use, your espresso machine
may develop a build-up of mineral deposits,
and therefore require occasional ‘descaling’.
We recommend descaling your machine
every 4-6 months, although this period
will depend on the hardness of water and
frequency of use.
Descaling Solution
You have 3 options:
A. Sunbeam Espresso Machine Descaling
Tablets (EM0010).
or
B.
Sunbeam Liquid Descaler (KE0100).
A & B Descaling options are available for
purchase from Sunbeam. Details are on the
back page.
or
C. White vinegar & warm water.
Descaling Program
The Descaling Program takes approximately
10 minutes to complete.
Preparing for Descaling
• Fill Water Reservoir with Solution
A. Fill Water Reservoir with 1 Litre of warm
water add one Sunbeam Descaling Tablet.
Allow tablet to fully dissolve.
or
B. In an empty Water Reservoir add half a
cap full of Sunbeam Liquid Descaler. Fill
Water Reservoir with 1 Litre of warm water.
Allow solution to mix thoroughly.
or
C. In an empty Water Reservoir add 1½
tablespoons of white vinegar. Fill Water
Reservoir with 1 Litre of warm water. Allow
solution to mix thoroughly.
- Place the Water Reservoir into position.
• Place Containers
Place a 1 Litre container under Group Head
and another 1 Litre container under the
Steam Wand.
• Power
Ensure that:
- Operating DIAL is in the vertical READY
position.
- The Power Plug is inserted into the outlet
and turned on.
- The machine is ON and in the Ready state.
• Access the Descaling Program
- Press & hold the ON/OFF BUTTON
for 4 seconds or until a flashing light
combination between the ON/OFF & READY
LIGHTS begins.
Important: If the Descaling Program
is not completed or stopped part way
through any of the Descaling Steps,
then you will need to start the Descaling
Program again from the beginning.
20
Descaling: Group Head & Steam Wand
ON /OFF
ON /OFF
READY
LIGHT
HOLD
4 SEC
Important: The Descaling Program
can be exited at any point if the DIAL is
returned to the vertical Ready position.
Important: If Descaling Step 1 isn't
started within 1 minute of entering the
Descaling Program, the machine will
exit the Descaling Program, and go back
to the Ready state.