What to do if my Sunbeam TORINO coffee does not come out?
If coffee isn't coming out of your Sunbeam Coffee Maker, several factors could be at play. First, ensure the reservoir has water. If it does, the coffee grind might be too fine; try using a medium grind. Also, avoid overfilling the filter or tamping the coffee too much. Finally, make sure the appliance is plugged in and turned on.
Why is my Sunbeam TORINO Coffee Maker coffee too weak?
If your coffee is too weak when using your Sunbeam Coffee Maker, there are a couple of things to check. If you're making a double shot of espresso, ensure you're using the large filter. Also, the ground coffee might be too coarse; try using a finer grind.
What to do if steam and hot water wands aren’t working on my Sunbeam TORINO?
If the steam and hot water wands aren’t working when using your Sunbeam Coffee Maker for the first time, even though the water reservoir is full, there might be air in the pipes. To resolve this, purge the machine by placing a large bowl under the steam wand and another under the hot water wand. Turn on both wands until steam and water appear, which may take a few minutes.
Why is coffee coming out around the edge of the filter in my Sunbeam TORINO?
If coffee is leaking around the filter's edge in your Sunbeam Coffee Maker, it might be due to a few reasons. Ensure the filter holder is rotated to the full lock position. Also, check for any coffee grounds around the filter basket rim and wipe them clean. Finally, make sure you are not using too much coffee in the filter; use less coffee.
What to do if my Sunbeam TORINO Coffee Maker coffee comes out too quickly?
If the coffee brews too quickly in your Sunbeam Coffee Maker, the issue might be related to the coffee grind or amount. Try using a finer grind of coffee. If that doesn't help, ensure you are using enough coffee in the filter; add more coffee.
Why is no coffee running through my Sunbeam Coffee Maker?
If no coffee is running through your Sunbeam Coffee Maker, several factors could be at play. Ensure there is water in the reservoir. If so, the coffee grind might be too fine, or there might be too much coffee in the filter basket. Also, verify that the machine is plugged in and turned on. Overly compacted coffee grinds or an incorrectly positioned water reservoir can also be culprits. To resolve this, add water if needed, use a coarser grind, reduce the amount of coffee in the filter basket, ensure the machine is powered on, refill the filter basket and tamp less firmly, and properly reposition the water reservoir.
What to do if coffee pours through Sunbeam TORINO Coffee Maker very slowly?
If coffee is pouring through your Sunbeam Coffee Maker very slowly, resulting in over extraction, it could be due to a few reasons. The coffee grind might be too fine, or there might be too much coffee in the filter basket. Additionally, the coffee may have been tamped too firmly, or the unit may be blocked by scale and coffee oil buildup. To address this, use a slightly more coarse grind, fill the filter basket with less coffee, tamp less firmly, and descale and clean the machine.
How to turn on Sunbeam TORINO Coffee Maker after it switched off?
If your Sunbeam Coffee Maker has switched off, it's likely in power-saving (sleep) mode, which activates after 1 hour of inactivity. To reactivate the machine, simply press any of the buttons on the control panel.
What causes coffee to pour too quickly from Sunbeam TORINO Coffee Maker?
If coffee pours too quickly from your Sunbeam Coffee Maker, resulting in under extraction, it might be because the coffee grind is too coarse, there's too little coffee in the filter basket, or the coffee wasn't tamped firmly enough. To fix this, use a finer grind, fill the filter basket with more coffee (or use a dual filter basket), and tamp more firmly.
Why is water not being pulled in from the reservoir in my Sunbeam TORINO Coffee Maker?
If the water reservoir isn't feeding water into your Sunbeam Coffee Maker, it might not be positioned correctly. Try pulling up the reservoir, reinserting it, and gently placing it down into the machine. Ensure the bottom of the reservoir is at the bottom of the machine to engage the reservoir mechanism. You may need to repeat this process a few times.
General| Brand | Sunbeam |
|---|---|
| Model | TORINO |
| Category | Coffee Maker |
| Language | English |
Step-by-step guide for making an espresso.
Instructions for steaming and texturing milk for beverages.
Guide on how to dispense hot water from the machine.
Cleans group head of residue for better extraction and machine maintenance.
Guides on filling, tamping coffee grounds for optimal espresso extraction.
Details on how espresso pours indicate quality, including shot clock and pressure gauge.
Details issues, causes, and solutions for extraction problems.
Techniques for positioning steam wand to create micro-foam and heat milk.
Adjusts water temperature for espresso pour, optimum 92-96°C.
Adjusts water volume for single or double espresso shots.
Keep steam wand clean for efficiency; clean immediately after use with damp cloth.
Guide on initiating and performing the coffee cleaning cycle.
Guide on initiating and performing the steam descaling cycle.
One-touch grinding directly into the group handle for fresh coffee on demand.
Grind cartridge allows easy access to burr chamber without altering settings.
Regularly clean burrs every three weeks for best performance and consistent grinding.
To Next Page