Operation manual of solar water controller SR868C8/SR868C8Q
---------------------------------------------------------------------------------------------------------------------------------------------------
- 17 -
temperature of second time section of heating
function
►Press “SET” button, “10” of hour time blinks
on screen
►Press “+”“-” button to adjust hour of time
►Repress “SET” button, “00” of minute time blinks on screen
►Press “+”“-” button to adjust minute of time
►Repress “SET” button, temperature “55℃”blinks on screen
►Press “+”“-” button, to adjust switch-off temperature of heating
► Press “ESC” to exit this set program, parameter is saved automatically
------------------------------------------------------------------------------------------------------------------
► Press “+” button, “tH 3o 17:00” displays on screen, set the switch-on time and
temperature of the third time section of heating function
►Press “SET” button, “17” of hour time blinks
on screen
►Press “+”“-” button, to adjust hour of time
►Repress “SET” button, “00” of minute time
blinks on screen
►Press “+”“-” button, to adjust minute of time
►Repress “SET” button, temperature “50℃” blinks on screen
►Press “+”“-” button, to adjust switch-on temperature of heating
►Press “ESC” to exit this set program and to the switch-off time and temperature set
►Press “+” button, “tH 3F 22:00” displays on screen, the switch-off time and
temperature of the third time section of heating function can be set
►Press “SET” button, “22” of hour time blinks
on screen
►Press “+”“-” button, to adjust hour of time
►Repress “SET” button, “00” of minute time
blinks on screen
►Press “+”“-” button to adjust minute of time
►Repress “SET” button, temperature “55℃” blinks on screen
►Press “+”“-” button to adjust switch-off temperature of heating
►Press “ESC” to exit menu, or wait for 20 seconds, set parameters are saved
automatically
Note: when no gas or oil boiler is installed in system, electrical heater can be installed
as back-up device, when electrical heater is in operation status, signal blinks on
screen.
To Next Page
Loading...