SUNFLOWER SR868C8 - PASS Password Setting

Operation manual of solar water controller SR868C8/SR868C8Q
---------------------------------------------------------------------------------------------------------------------------------------------------
- 33 -
displays, P1 output is switched-off
►Press “ESC” to exit P1 set program
------------------------------------------------------------------------------------------------------------------
►Press “+” button, “HND2 off” displays on the
screen, P2 output manually set
►Press “SET” button, “HND2on” displays on
the screen, P2 output is switched-on
►Repress “SET” again, “HND2off” displays,
P2 output is switched-off
►Press “ESC” to exit P2 set program
------------------------------------------------------------------------------------------------------------------
►Press “+” button, “HND3 off” displays on the
screen, R1 output manually set
►Press “SET” button, “HND3 on” displays on
the screen, R1 output is switched-on
►Repress “SET” again, “HND3 off” displays,
R1 output is switched-off
►Press “ESC” to exit R1 set program
-------------------------------------------------------------------------------------------------------------------
►Press “+” button, “HND4 off” displays on the
screen, H1 output manually set
►Press “SET” button, “HND4 on” displays on
the screen, H1 output is switched-on
►Repress “SET” again, “HND4 off” displays,
H1 output is switched-off
►Press “ESC” to exit H1 set program
------------------------------------------------------------------------------------------------------------------
Note: when manual mode is activated，signal displays on the screen, after 15
minutes all outputs are switched-off, controller exits manual mode automatically.
4.8 PASS Password setting
Setup steps:
To access main menu PASS,