Operation manual of solar controller SR1568
Page 8 of 87
Put the cover on the housing. Attach with the fastening screw.
3.2 Wiring connection
According to the way of installation, wire can be connected from hole A on the bottom plate or
from hole B, using a suitable tool (like knife) to cut the plastic of A.
Note: wires must be fastened by fixing clamps on position C.
3.3 Terminal connection
Note: before opening the housing! Always disconnect the controller from power
supply and obey the local electrical supply regulation.
Input terminals
T0～T1： PT1000 temperature sensor, for measuring the temperature of collector and
To Next Page
Loading...