Sunny PERFORMANCE INTERACTIVE Series - STEP 2: Attach Handlebar Post

5
We value your experience using Sunny Health and Fitness products. For assistance with parts or
troubleshooting, please contact us at support@sunnyhealthfitness.com or 1-877-90SUNNY
(877-907-8669).
STEP 2:
Remove 4 Screws (No. 12), 4 Spring
Washers (No. 25) and 4 Arc Washers (No.
24) from the Main Frame (No. 1) using Allen
Wrench (No. 100).
NOTE: Make sure the Tension Controller
(No. 50a) is at the lowest level before you
connect the cable. This ensures the wires
are at their longest point. We recommend the
assistance of a second person to help hold
the Handlebar Post (No. 2). This will make
the connection easier when you are
attaching Tension Hook (No. 53) to the
Tension Cable (No. 50b).
Attach the Tension Cable (No. 50b) into the
metal bracket of Tension Hook (No. 53) as
shown in drawing A-①. Then, pull Tension
Cable (No. 50b) upward and insert it into the
slot of metal bracket of Tension Hook (No.
53) as shown in drawing A-③. Make sure the
metal fitting on Tension Cable (No. 50b) is
secured in the metal bracket.
Connect the Sensor Extension Wire 1 (No.
52) to the Sensor Extension Wire 2 (No.
51).
Attach the Handlebar Post (No. 2) to the
Main Frame (No. 1) with 4 Screws (No. 12),
4 Spring Washers (No. 25) and 4 Arc
Washers (No. 24) that were just removed.
Tighten and secure with the Allen Wrench
(No. 100).
NOTE: Do not cut or pinch any wires when
attaching the Handlebar Post (No. 2).