2
5.
6.
WARNING: THE SPRING CLIPS COULD HAVE
SHARP EDGES. TO PREVENT THE RISK OF INJURY,
USE SAFETY GLOVES WHEN REMOVING OR
REPOSITIONING THE SPRING CLIPS ON THE ROLLER
BAR. FAILURE TO DO SO COULD CAUSE PERSONAL
INJURY.
Figure 5
Figure 6
NOTE: While installing the provided Double Sided
Adhesive Tape, Do Not Remove the backing from the
tape unl instructed to do so.
Housing
End Plate/Motor
Fabric on
Roller Bar
Leading Bar Inside
Boom Pleat
Figure 8
Roller Bar
Roll the Fabric onto
the Leading Bar
Figure 7
Spring Clip
Roller
Bar
Raised Guide
Fabr ic
Do not remove the backing of the tape, yet.
See
Figure 8
Figure 9
To Next Page
Loading...
