SunSetter EASYSHADE - Page 3

3






See 
Note: You may choose to use tape or have your
helper temporarily hold the Fabric in place on the
Roller Bar as you complete the following step.




Figure 11
Roller Bar
FIGURE X
Roller Bar
FIGURE X
FIGURE X
Spring
Clip
Fabric
Roller Bar
Spring Clip
Installation
Spring Clip
Removal
Figure 13
Roller Bar
FIGURE X
Roller Bar
FIGURE X
FIGURE X
Spring
Clip
Fabric
Roller Bar
Spring Clip
Installation
Spring Clip
Removal
Figure 13a
Figure 10
Figure 11
Double
Sided
Tape
Raised
Guide
Notched End
of Roller Bar
Fabric Rolled on
the Leading Bar
Fabric
Roller Bar





NOTE: The Roller Bar has a Notch cut into one end,
this is the end of the Roller Bar that the Motor will
be installed. If your Motor will be on the right when
you face your installed EasyShade, then the Notch
in the Roller Bar will be on the right for the Fabric
installaon. If your Motor will be on the le when
you face your installed EasyShade, then the Notch
in the Roller Bar will be on the le for the Fabric
installaon. Le and right references are as you face
the Roller Bar, with the Fabric on the opposite side.
Note: One (1) Clip will be installed over the Fabric
on each end of the Roller Bar, approximately one
(1) inch from the outer edge of the Roller Bar. All
remaining Clips will be installed equally distanced
along the Roller Bar, between the two (2) End Clips.
See Figure 13.





WARNING: THE SPRING CLIPS COULD HAVE
SHARP EDGES. TO PREVENT THE RISK OF INJURY,
USE SAFETY GLOVES WHEN REMOVING OR
REPOSITIONING THE SPRING CLIPS ON THE ROLLER
BAR. FAILURE TO DO SO COULD CAUSE PERSONAL
INJURY.
Figure 12