STEP 7. At each end of the EasyShade Housing Assembly you will find a Vinyl Coated Cable, you will
need to unroll this cable and allow it to hang flat against the mounting surface. (See Figure 6)
STEP 8. Insert the Vinyl Coated Cable located at each end of the Housing Assembly through the
guide holes at each end of the EasyShade drop down panel. (See Figure 7)
STEP 9. Determine how far down your EasyShade will be extended (this is limited to the length of
the Vinyl Coated Cable, but you may not exceed 84" from the bottom of the EasyShade housing).
Below each end of the EasyShade Housing Assembly, mark a horizontal line on the wall. (See Figure
8)
STEP 10. Using the Vinyl Coated Cable as a guide, ensure the cable is straight and plumb and mark
a vertical line where it crosses the horizontal lines
STEP 11. Locate the Cable Guide Brackets and Cable Guide stops in your hardware package.
STEP 12. Align the top of the Cable Guide Brackets below the horizontal line and centered on the
vertical lines as shown in Figure 10. Ensure the bracket is plumb and mark both screw hole
locations. Remove the bracket and pre-drill both screw hole locations with a 1/8" drill bit. Repeat for
the other side of the EasyShade.
To Next Page
Loading...
Need help?
General
