SunSetter EASYSHADE Instructions

APPENDIX A
Adjusting the Open and Close Limits of the EasyShade Motor
APPENDIX B
Resetting the EasyShade Motor
This procedure describes the actions needed to reset the communication between the motor and the
remote transmitter that’s supplied with your motorized EasyShade. This procedure should only be
performed if the remote transmitter does not operate the motorized EasyShade. Please review the
steps below to familiarize yourself with the procedure before attempting to complete them.
To Reset the Motor:
You will need to disconnect power (120V AC) for 2 seconds, reconnect for 10 seconds, disconnect for
another 2 seconds and reconnect. The motor should start to move and then stop on its own (if this
does not happen, continue to perform the disconnects until it does). Once the motor stops moving
on its own, press and hold the Program button on the back of the remote and count to ten without
letting go. The EasyShade will jog twice a few seconds apart The motor has no w been reset.
Complete steps 1 thru 6 below to restore communication to the transmitter, verify the motor
rotation and to reset the Open and Close positions for the EasyShade.

SunSetter EASYSHADE Specifications

General

Brand	SunSetter
Model	EASYSHADE
Category	Accessories
Language	English