SunSetter EASYSHADE Replacement Instructions

SunSeer Products, a Massachuses Limited Partnership, 184 Charles Street, Malden, MA 02148
Rev. 04/22/2014
ES_Solar_Motor_Repl_Instr
Appendix A



Tools needed: A pen or similar poinng device is needed to press and hold the Programming Buon
on the Remote Transmier.
WARNING: THIS PROCEDURE MUST BE FOLLOWED THOROUGHLY AND COMPLETELY.
SET PROPER DIRECTION OF THE MOTOR ROTATION
1. Press and Hold the UP and DOWN
short movement of the Motor, usually a brief Up and Down movement.

a. Press the UP
b. Press the DOWN
c. my

SET THE UP AND DOWN POSITIONS
3. Use the UPUp

4. Press and Hold the my and DOWN
EasyShade begins to move Down.
5. Press the myStop the EasyShade at (or close to) the desired Down

Housing.
6. Use the UP and DOWNDown
7. Press and Hold the my and UP
EasyShade begins to move. Let the EasyShade stop at the Up
8. Press and Hold the my
9. Press and Hold the Programming
10. Process is complete. Test the EasyShade for correct Up and Down
Front View
Rear View
UP
my
DOWN
Programming
TO CHANGE AN EXISTING UP OR DOWN STOP POSITION
1. Press the UP or DOWN
EasyShade stop on its own.
2. Press and hold the UP and DOWN

3. UP and DOWN
4. Press and hold the my
5. 

SunSetter EASYSHADE Specifications

General

Brand	SunSetter
Model	EASYSHADE
Category	Accessories
Language	English