42
Save
Select the Model
Desired
Move to B-56Parameter B Group Initial Screen
Program Enable
6) Motor Controller Setting
(1) Controller Setting by Machine Type
Classification
1
2
3
SC-7300 Series
SC-7500 Series
SC-7310 Series
88
124
125
Parameters are set according to the
ordered specifications before
machine's shipment from the
factory.
Machine Type Set Value for Parameter B-56 Model Remarks
※ Model Number Setting
[Note]
① Before the product is shipped out from the factory, all settings are completed in line with the machine type ordered.
② In case where the controller which is different from the ordered specifications is installed to the chain-type machine:
⇨ Set the value of parameter B-56 according to the concerned machine type.
⇨ Depending on the program version of controller, it may not be applicable to some machines. See the following to make the
proper setting according to the machine type.
※ Version display
When the power is turned on, the CPU version is displayed as below on P/U for a moment, and then the screen moves to the initial
screen ("3333").
This is an old version where the CPU version is not displayed.
“POWER ON”+ + or
⇨
or
⇨⇨
⇨⇨
Classification Fortuna Series III(CPU version 11) Fortuna Series IV(CPU version 7)
Program Unit
(P/U)
Handy Controller
⇨ ⇨
To Next Page
Loading...
