To Next PageTo Next Page
Need help?Do you have a question about the SunStar Fortuna 5 Series and is the answer not in the manual?
Product purpose, working conditions, installation, and disassembly procedures.
Guidelines for service, maintenance, and additional safety measures.
Rules for pedal, power, grounding, and shock avoidance.
Power strip usage, noise sources, and location requirements.
Belt tension, cleaning, fuse replacement, and cable management.
Step-by-step guide for mounting the servo motor onto the sewing machine table.
Instructions for fitting the belt cover and setting optimal belt tension.
Covers mounting and adjusting foot-lift solenoids for different models.
Details on mounting the position sensor and adjusting the film.
Procedures for equipping and adjusting the built-in location detector.
Instructions for mounting the Program Unit (P/U).
Details power plug specs and wiring material requirements.
Identifies connectors and explains solenoid voltage adjustment.
Connect motor and machine using the ground wire.
Checks to perform before powering on the machine.
Classifies backtack sewing conditions for correction.
Methods to correct start/end B/T stitch numbers when stitches are off.
Correcting stitch counts for less than or more than one stitch deviation.
How to initialize software and recall needle stop location.
Using Program Unit, Simple Box, and parameter groups.
Lists common error indicators, causes, and troubleshooting steps.
General