60
No. Function StepRangeInitial value
※ Items No. 40~53 : functions that check if solenoid and other output signals are working properly.
※ Select Item No. 55 and press the Enter key. Along with the buzzer sound you will see the words “Seq 55”appear on the screen.
Thread trimming sequence composition permitting condition is now possible. You can program a thread trimming sequence to a
maximum of 64 bytes. (For thread trimming sequence program method, refer to attached material).
40 Checks operation of B/T solenoid (OUTPUT00)
41 Checks operation of P/F solenoid (OUTPUT01)
42 Checks operation of T/T solenoid (OUTPUT02)
43 Checks operation of W/P solenoid (OUTPUT03)
44 Checks operation of T/R solenoid (OUTPUT04)
45 Checks operation of left solenoid (OUTPUT05)
46 Checks operation of right solenoid (OUTPUT06)
47 Checks operation of Aux. solenoid (OUTPUT07)
48 Checks operation of Left LED solenoid (OUTPUT10)
49 Checks operation of Right LED solenoid (OUTPUT11)
50 Checks operation of needle when signal notifies up stop (OUTPUT12)
51 Checks operation of needle when signal notifies down stop (OUTPUT13)
52 Checks operation of signal notifying motor running (OUTPUT14)
53
Checks operation signal notifying target speed has been reached
(OUTPUT15)
Select [Thread trimming sequence]
- The default is set to '0'. If you wish to input another sequence apart
54 from the thread trimming sequence provided in 0 0~64 1
the system input the newly composed sequence number.
(Refer to the sequence composition method)
55 Thread trimming sequence data writing function
Selecting sewing machine model
- write the number that fits the sewing machine model provided in
the full function manual.. 1
56
- thread trimming sequence in the pertinent machine is copied.
0 0~127
0~ 74
- if you want to correct the thread trimming sequence, change (non-order made)
the contents of item B-55. (※However, be aware that if you initialize 75~118
the parameter, the newly programmed changes will disappear and (order-made)
the thread trimming sequence will change to that of [SunStar 235/250]).
(Refer to attached material)
57 Independent operation of trimming sequence 0 0/1
0=operation after trimming
1=independent operation
58
Presser foot-lift solenoid slowing down time #1
40ms 2~510ms 2ms
(Applied only when it is full-on condition)
59
Presser foot-lift solenoid slowing down time #2
30ms 2~510ms 2ms
(Applied only when it is PWM)
※After matching the number of the solenoid being
tested, press the “+1stitch( )”key(button
in case of simplified
operation) and check the condition of the
movement.
- Along with the output, it will say “on”, or “off”
Caution
If the specific items of the parameter are changed carelessly, they could break down or damage the machine, so the
user must be well-trained before using it.
To Next Page
Loading...
