18
3) Adjustment of belt tension
4) Installation of belt cover
[ Warning ]
Be sure to turn the power switch off before adjusting belt
tension.
[ Warning ]
Always install the belt cover for safety.
Turn the screw④ of the motor③ around. Adjust the belt ①
to go in approximately 10~20mm when its center portion is
pushed with a finger. (Refer to figure 13)
[ Figure 13 ]
Fasten the belt cover (upper)① with a screw② as shown in figure 14. For A-Type table, mount the belt cover (lower)③ as
shown in figure 15.
①
④
③
②
10~20mm
[ Figure 15 ][ Figure 14 ]
①
②
③
To Next Page
Loading...
