62
Loosen the screw⑩ to adjust the location of or remove the
suction pipe(A) ⑨.
Install the suction pipe(A) ⑨ 5mm away on the left side of
the moving mes(left) holder cover plate⑦.
※ Compressed air-based extraction
Set the extraction power at the lowest possible pressure
for chip extraction. Adjust the chip extraction power,
using the speed controller⑧.
※ Vacuum system-based extraction
Connect the curved hose to the vacuum dust collector.
Set the extraction power at the lowest possible pressure
for chip extraction. Adjust the vacuum system to change
the extraction power.
2) Adjustment of suction pipe(A)
[ Figure 103 ]
⑦
⑨
⑩
⑧
5mm
The length of fabric to be cut should be adjusted in the
following order:
(1) Loosen the screws for the fixed mes (left mes) holder
and the collar.
(2)
Move the fixed mes(left) holder⑬ to the desired position.
(3) Tighten the screws⑭ of the fixed mes(left) holder⑬.
The tightening torque is 1.5~2N
•
m (15~20kgf
•
cm).
(When shipped out from the factory, the distance between
the left collar⑮ and the right collar⒔ is set at 9mm.)
(4) Loosen the screw⒕ of the collar(right)⒔.
(5) Place a strand of thread between the fixed mes(left)②
and the moving mes(left)①, and check whether the
pressure applied to the moving mes(left) is proper. Turn
the pulley manually [Fig. 106].
4) Cutting length (Location of fabric cutting)
[ Figure 105 ]
⑬
⒃
⑮
⒕
⒔
ⓐ
⑭
When adjustment is completed, loosen the screw⑫ on the
suction pipe cover plate⑪, and align the right side of the
cover plate with the pipe entrance.
3) Adjustment of the suction pipe cover plate
[ Figure 104 ]
⑪
⑫
Regularly supply oil through the oil hole
ⓐⓐ
.
Note
Turn off the motor switch before making any adjustments. Make sure that the motor is completely
turned off.
Warning
To Next Page
Loading...
