63
(6) Adjust the moving mes(left)① and the fixed mes(left)
② to set the position of 7mm away from the end of the
moving mes (around the root area of the moving
mes(left)) to be at the same height of the front face of the
fixed mes(left).
Afterwards, tighten the screw⒃ of the collar(left)⑮.
(7) Check whether the meses (knives) are operating
properly.
[ Figure 106 ]
②
Needle
Plate
7mm
①
※ How to remove the fixed mes(left)
(1) Loosen the screw⒃ of the collar(left)⑮.
(2) Move the moving mes(left) holder③ to the left side and
make space between the moving mes(left)① and the
fixed mes(left)②.
(3) Tighten the screw⒃ of the collar(left)⑮.
(4) Loosen the screw④, which fixes the moving mes(left)
②, and lower the fixed mes(left)②.
5) Removal and installation of the fixed mes (left)
[ Figure 107 ]
⒃
⑮
※ How to install the fixed mes (left)
(1) Set the height of the fixed mes(left)② and the height of
the needle plate front face to be same and tighten the
screw④.
(2) Loosen the screw⒃ of the collar(left)⑮, and use the
spring pressure to make the moving mes(left)① and the
fixed mes(left)② contact each other.
(3) Place a strand of thread between the moving mes(left)①
and the fixed mes(left)② to check whether the pressure
applied to the moving mes(left) is appropriate. Turn the
pulley manually.
(4)
Adjust the moving mes(left)① and the fixed mes(left) ②
to set the position of 7mm away from the end of the
moving mes (around the root area of the moving mes(left))
to be at the same height of the front face of the fixed
mes(left). Tighten the screw
⒃
of the collar(left)⑮.
(5) Check whether the meses (knives) are properly operating
once again.
[ Figure 108 ]
③
①
②
④
Turn off the motor switch before making any adjustments. Make sure that the motor is completely
turned off.
Warning
To Next Page
Loading...
