64
▶ How to install the moving mes(left)
(1) Assemble the moving mes and the moving mes holder
using the moving mes holder pin.
(2) Loosely assemble the moving mes shaft⑤ and the
moving mes holder using the screw③.
Make sure that the distance between the moving mes
holder cover plate and the end of the shaft is 6.5mm.
(3)
Manually turn the pulley to lower the moving mes(left)①.
When the mes (knife)① is located at the dead point,
move the moving mes(left) holder④ to place the end of
the moving mes(left) blade 0.5mm above the front face
of the fixed mes(left).
Then tighten the screw③ of the moving mes(left) holder
④.
(4) Loosen the screw⒃ of the collar(left)⑮, and use the
spring pressure to make the moving mes(left) and the
fixed mes(left) contact. [Fig. 107]
(5) Place a strand of thread between the moving mes(left)①
and the fixed mes(left)② to check whether the pressure
applied to the moving mes(left) is appropriate. And turn
the pulley manually.
(6) Adjust the moving mes(left) and the fixed mes(left) to
set the position of 7mm away from the end of the
moving mes(left)① (around the root area of the moving
mes(left)) and the front face of the fixed mes(left)② to
be at the same height. Then tighten the screw⒃ of the
collar(left)⑮. [Fig. 107]
(7) Check whether the mes(knife) is properly operating once
again.
6) Installation of the moving mes(left)
②
①
[ Figure 109 ]
④
⑤
③
[ Figure 110 ]
[ Figure 111 ]
⑤
④
7mm
Needle
Plate
6.5mm
Turn off the motor switch before making any adjustments. Make sure that the motor is completely
turned off.
Warning
To Next Page
Loading...
