30
2) Adjustment of looper thread tension
[ Warning ]
Be sure to turn the power switch off before adjusting tension.
As a standard, the center of the thread hole of the looper
thread guide ② and ③ is generally positioned along the line
of the looper thread guide bracket①.
Loosen the screw to lower the looper thread guide down to
decrease the looper thread tension, and raise it up to increase
the tension.
※ When using the woolly thread, bring the looper thread
guide(②, ③) down as much as possible, and do not
insert thread into disc ④.
[ Figure 39 ]
3) Adjustment of needle and spreader
[ Warning ]
Turn the power switch off before adjustments
⑴ Installation of spreader
When the spreader① moves to the left, the clearance between the left needle and the hook tip of the spreader (a) is
0.5mm ~ 0.8mm. (Figure 40)
When the spreader sits at the far left, the distance from the left needle center to the hook tip of the spreader (a) is 4.5mm ~
5.5mm.
The height between the stitch plate and the lower side of the spreader① is 8.5mm ~ 9.5mm. (Figure 41)
The spreader can be adjusted by untightening the spreader fixing screw② and the spreader handle fixing screw③.
(Figure 42)
[ Figure 40 ] [ Figure 41 ] [ Figure 42 ]
③
④
②
①
①
a
0.5~0.8mm
4.5~5.5mm
8.5~9.5mm
①
③
②
To Next Page
Loading...
