50
[ Warning ]
Before adjustments, always turn off the motor switch and check to make sure that the motor is in stop mode.
A. Position the moving blade ① to the left.
B. When the distance between the endpoint of the
moving blade ① and the right endpoint of the looper
is 12mm, adjust to bring the endpoint towards the
center of the looper.
C. To move the endpoint back, loosen the screw to
turn the hinge (R) for blade guide lever clockwise.
To move the endpoint front, turn the hinge
counter-clockwise.
D. Fasten the screw afterwards.
(8) Position of moving blade point
[ Figure 80 ]
①
12mm
[ Figure 81 ]
To Next Page
Loading...
