19
(3) Sewing Operation
Ex) Do sewing work according to P1 and then according to P3.
A. Turn on the power.
B. Press .
C. Press . READY lamp will turn on and feed plate will move and go up.
D. Check the pattern shape (refer to <Checking Pattern Shape> section).
E. After checking, you can start sewing.
F. After sewing is completed, press . Feed plate will search the original point and move to the starting point.
(You can change the pattern with a short key (single press) even with the READY lamp on).
G. Perform D and E of the above procedures.
※ P1-P26 will be displayed when changing pattern using or .
–/BACK+/FORWARD
P3
READY
P1
5-2) Sewing using Combination Function
You can list the pre-registered user programs (P1-P26) in Cnb1 and Cnb2 and change the pattern in the order of the programs
on the list.
※ Maximum number of program combinations you can register in Cnb1 and Cnb2 is 30.
(1) Registration of Combinations
Ex) Combine P1, P2, and P3 (in that order) and register the combination in Cnb1.
A. Turn on the power pressing and .
B. Press and then .
C. Press and then .
D. Press and then .
E. Press to complete the registration.
F. Turn off the power and turn it on again.
※ To register in Cnb2, press and in A of the above procedure.
SELECTP2
READY
P3SELECT
P2SELECT
P1SELECT
SELECTP1
Cnb1
03.03
Cnb1
01.01
02.02
0 to 99 ↔ P1 to P26
Unregistered programs will not be displayed.
Patterns that are not registered with function keys (P1-P26) cannot be combined.
Caution
To Next Page
Loading...
