7
Bartack Series is made to sew patterns on fabrics and other similar material for
manufacturing. Follow the following indications when operating the machine.
ⓐ Read through this manual carefully and completely before operating the machine.
ⓑ Wear the proper clothes for work.
ⓒ Keep hands or other parts of the body away from the machine operation parts(needle,
shuttle, thread take-up lever, and pulley etc.) when the machine is being operated.
ⓓ Keep the covers and safety plates on the machine during operation.
ⓔ Be sure to connect the earthing conductor.
ⓕ Close down the electric motive power and check if the switch is turned “off”before
opening electric boxes such as the control box.
ⓖ Stop the machine before threading the needle or checking after work.
ⓗ Do not step on the pedal when turning the power on.
ⓘ Do not use several motor per a electric outlet.
ⓙ If possible, install the machine away from loud noise such as high frequency welding
machines
ⓚ Be careful when the upper feed plate comes down to press. Otherwise, the finger or hand
height be hurt at smacking.
1-4) Machine
Operation
Caution
Caution
ⓐ Safety label : It describes cautions during operating the sewing machine.
ⓑ Thread take-up cover : It prevents from any contact between body and take-up lever.
ⓒ Motor cover : It prevents from accidents during rotation of motor.
ⓓ Label for specification of power : It describes cautions for safety to protect against
electric shock. (Voltage and Hz)
ⓔ Finger guard : It prevent from contacts between a finger and needle.
ⓕ Safety plate : It protects eyes against needle breaks.
1-5) Devices for
Safety
1) Make sure that the cover is in place, while the machine is
operating. Otherwise, the belt might injure or cut a finger.
2) Make sure that the power is turned "OFF" before examining
or adjusting the machine.
Warning
ⓒ
ⓐ
ⓑ
ⓕ
ⓔ
ⓓ
To Next Page
Loading...
Need help?
General
