SunStar SPS/E-BS1201H - SM Operation 2 (Advanced); 5-1) User Program

18
55
SM Operation 2 (Advanced)
5-1) User Program
You can register and use 26 different programs (P1-P26) as user programs.
The 26 user programs can hold information, i.e. pattern number, X scale %, Y scale %, and sewing speed.
It will be convenient for you to register repeatedly used patterns in the user program.
(1) Registering the User Program
(2) Selecting the User Program
A. Press and turn on the power.
B. Press .
C. Press to display number items
Press , to set the pattern number at 3.
D. Press and use , to set the X scale %
at “50%” and Y scale % at “80%” and the maximum speed limit at “1800
spm”.
E. Press to end registration.
※ To register P2-P26, press P2-P26 in B of the above and follow the rest
of the procedures.
F. After registration, turn off the power and turn it on again.
READY
–/BACK+/FORWARDSELECT
–/BACK+/FORWARD
SELECT
P1
SELECT
P–––
P01–
3
50
󳥴
󳥴
󳥴
󳥴
P–––
󳥴
80
󳥴
1800
󳥴
Ex) Registering the following set-up as P1.
Pattern Number 3
X scale %: 50%
Y scale %: 80%
Maximum speed limit: 1800spm
Reg.
No.
P01
P02
P03
P04
P05
P06
P07
+
P2P1
P6
P5
P4
P3
P2
P1
P08
P09
P10
P11
P12
P13
P14
P15
P16
P17
P18
P19
P20
P21
P22
P23
P24
P25
P26
+
+
+
+
+
+
+
P5P2
P4P2
P3P2
P6P1
P5P1
P4P1
P3P1
+
+
+
+
+
+
+
P6P5
P6P4
P5P4
P6P3
P5P3
P4P3
P6P2
++
++
++
++
++
P6P5P4
P6P2P1
P5P2P1
P4P2P1
P3P2P1
Key(s) Key(s) Key(s) Key(s)
Reg.
No.
Reg.
No.
Reg.
No.
By default, P1-P26 contain information of pattern number 1, X & Y scale 100%, and speed 1500.
To not display P1-P26 mark when scrolling the pattern numbers, set the pattern number “0” in
C of the above procedures.
Caution