35
(3) Formatting Scalable Memory
You can turn the memory (where you downloaded patterns) to the default status.
1) Turn on the power pressing and at the
same time.
2) Memory will be formatted with the screen like below.
◀ CAUTION ▶
All of your downloaded patterns will be erased.
P3–/BACK
P3
7-4) Other Functions
(1) Initializing Memory Switch
You can initialize the memory switch back to the default condition.
1)
Turn on the power pressing and
at the same time.
2) Memory switch will be initialized with the screen like
below.
3) You will soon see the initial screen.
◀ CAUTION ▶
Memory switch initialization will remove all of your
memory switch set-ups.
–/BACK+/FORWARD
(2) Inertia Tuning
The controller performs an automatic inertia tuning suitable to the machine load.
Do not perform this function unless tracking of the sewing speed is too slow or the machine stops at one stitch later.
1)
Press and at the same time to turn the
power on.
2) The following screen appears.
3) Press the foot pedal until it moves to Step 2. The inertia
tuning is automatically conducted.
◀ CAUTION ▶
After inertia tuning, the needle bar is stopped at a
random position. Therefore, place the needle bar at
the origin position, and turn off the power. Soon
after, turn on the power again.
–/BACKREADY
To Next Page
Loading...
