SunStar SPS SERIES - ASSEMBLY AND INSTALLATION PROCEDURES; TYPICAL LAYOUTS AND TUBE ASSEMBLY

Form 43343320
-12- Dec 2017
7.0) TYPICAL LAYOUTS – SPS/SPU SERIES
MODEL
EMITTER LENGTH
MODEL
BODY LENGTH
Min.
Max.
Min.
Max.
SPS 40
10 Ft.
20 Ft.
SPU 40
10 Ft.
10 Ft.
SPS 50
20 Ft
40 Ft.
SPU 50
10 Ft.
20 Ft.
SPS 75
20 Ft.
40 Ft.
SPU 75
10 Ft.
20 Ft
SPS 100
30 Ft.
50 Ft.
SPU 100
15 Ft.
25 Ft.
SPS 125
30 Ft
60 Ft.
SPU 125
15 Ft.
30 Ft.
SPS 150
40 Ft.
60 Ft.
SPU 150
20 Ft.
30 Ft.
SPS 175
50 Ft.
70 Ft.
SPU 175
25 Ft.
35 Ft.
SPS 200
50 Ft.
70 Ft.
SPU 200
25 Ft.
35 Ft.
NOTES:
1. In all configurations, the control unit must be connected directly to either a) the 12-radial hole flange of the
10 ft. aluminized steel starting body section (for 10 ft., 20 ft., and 30 ft. systems) or b) the 6-hole flange of
the 10 ft. alumi-therm steel starting body section (for 40 ft., 50 ft., 60 ft., and 70 ft. systems).
2. Joining of two 90º elbows directly together to form a “Z” shape IS NOT permitted.
3. SPS / U 175 - 40 ft length available for special applications.
4. 5 Ft. Body Packages may be utilized on any of these heaters to yield heater lengths from 15 ft. to 70 ft.
5. Any configuration of components not shown in the illustrations may be used except as noted in 1 and 2
above.