Form 43343320
-24- Dec 2017
11.0) ADDING OPTIONAL 90º ELBOW (SPS ONLY)
1. The optional 90º elbow must be located a minimum of 10 ft. after the burner box.
2. Hang the body sections in a 90º ("L") shaped pattern. Allow spacing for the elbow. The distance from one
end of the elbow to the centerline of the opposite leg is 13" as shown.
3. Join the tube ends of the body sections and the elbow together and secure with tube couplings as described
in Section Error! Reference source not found..
11.1) ADDING OPTIONAL CORNER REFLECTOR (SPS ONLY)
1. Place the corner reflector over the reflectors of both body sections.
2. Secure by sliding speed clips on the reflector edges. One speed clip is required for each side of reflector.
3. The corner reflector can be used only when the long axis of the heater is level and mounted in a horizontal
position.
To Next Page
Loading...
