Form 43343320
-62- Dec 2017
25.0) REPLACEMENT PARTS GUIDE
Speed Clips (for air inlet plate)
HHTCS #8-32 x 3/8" (green coated)
HWHSMS #8 x 1/2” “B” Point (typical all access panels)
Housing Assembly (painted)
Valve Holder Plate (painted)
Access Panel – Top (painted)
Access Panel - Hinged (with module holes)
Access Panel - LH burner end –with sight glass (painted)
Access Panel - RH burner end (painted)
Combustion Air Plate (see size requirements in Section 5.0)
Burner, Investment Casting - Machined
Manifold Support Bracket (painted)
Manifold Extension Bracket (with set screw)
Spark Module – Fenwal-24V #35-615950-197
Terminal Bushing (3 x 1/4” tabs)
Fuse 1/4 x 1-1/4” (2 amp)
Terminal Bushing (2 x 1/4” tabs)
Transformer 120v-24V 20VA
Strain Relief #SR-6P3-4 (ignition cable)
Strain Relief #SR-2M-1 (flame sensor wire)
Grommet .250ID #739 (air sensing tube)
Split Bushing #2871 (misc. wiring, ignition cable, sensor wire)
Grommet, Pipe Sealing 1/2" #63595K34
Air Sensing Tube Asm. (straight) 1/4"od
Air Sensing Tube Asm. (90 deg bend) 1/4"
Cord Connector 1/2” #M4521 (Gray)
Plastic Vacuum Air Tube 10" (P2- to static pressure point)
Plastic Vacuum Air Tube 10" (P1+ to total pressure point)