Form 43343320
Dec 2017 -63-
Supply Cord Set (SVT-1 18/3 x 72" long) – includes connector & nut
Sealing Strip 1/8" x 3/8" wide (access panels) -not shown-
Starting Collar (combustion air inlet)
Ignition Cable - Female (2) 1/4" QC x 24"lg #PSE-GF23 -not shown-
Kit, Gas Valve – WR #36J23-203B1 Single Stage (natural gas)
Kit, Gas Valve – WR #36J23-204B1 Single Stage (propane gas)
Kit, Gas Valve – WR #36J58-201B1 Two Stage (natural gas)
Kit, Gas Valve – WR #36J58-202B1 Two Stage (propane gas)
Main Burner Orifice #7/16-27 (see size requirements in Section5.0)
Air Restrictor Plate 2-3/4” (earlier models only)
Burner Screen Sub-Assembly (200 BTU units only)
Monitoring Light – Amber (gas valve operation) – 2 each for Two Stage
Monitoring Light – Red (air switch operation)
Air Switch (set point @ .93”WC, RED LABEL) SPS/SPU40 & 50
Air Switch (set point @ .65”WC, BLUE LABEL) SPS/SPU75 & 100
Air Switch (set point @ .34”WC, GREEN LABEL) SPS/SPU125,150,175 & 200
Label, Nameplate – Single Stage
Label, Nameplate – Two Stage
Label, Logo (SunStar) (Not Shown)
Label, Clearances to Combustibles
Label, Wire Connection Diagram – Single Stage
Label, Wire Connection Diagram – Two Stage
Label, Warning (installation/configuration/chemical)
Label, 24V Thermostat Connection – Single Stage
Label, 24V Thermostat Connection – Two Stage
Label, Eyebolt Suspension Warning
Label, Gas Valve in “OFF” Position
Label, Burner Warning (access panel must remain closed)
Label, Flex Gas Connector
Label, Ladder Wiring Connection – Single Stage
Label, Ladder Wiring Connection – Two Stage
Label, Low/High Fire – Two Stage
Installation & Operation Manual (Not Shown)
Tube Integrity Safety Switch (TISS) Components
TISS replacement assembly (does not include retainer clamp or spring)