Form 43343320
Dec 2017 -23-
2 Ft. Turbulator Sections
10.3) ADDING BODY REFLECTORS
1. Slide the reflectors on the tube support/hanger brackets and through the wire hangers.
2. The tube at the coupling joints must be covered. Slide the reflectors together and provide an overlap of two
(2”) inches for the first reflector overlap after the control unit. All remaining reflector overlaps will be
approximately one (1”) inch. This will allow for the natural expansion and contraction of the heater when in
operation. Note: The heaters can expand and contract up to 1-3/4”.
3. Secure the reflectors as shown in Detail “A” using #10 x 1/2” self-drilling sheet metal screws at each tube
support/hanger bracket.
To Next Page
Loading...
