SunStar SWF/C-UK1502 User Manual

2-5
3) Insert the table and fasten the bolts and the clamps.
[Fig.2-9]
[Fig.2-10]
[CAUTION]
The table should not be higher than the upper side of the needle plate by 0.5mm for board frame
work. If the height difference is over 0.5mm, unfasten the table support bolts, adjust the height, and
fasten the bolts back.
Clamp
Clamp
Clamp
Table support
Bolts
height difference
if gap is larger
than 0.5mm
Table support
Bolts

SunStar SWF/C-UK1502 Specifications

General

Brand	SunStar
Model	SWF/C-UK1502
Category	Sewing Machine
Language	English