4-2
12) AUTOMATIC DETECTION OF UPPER AND LOWER THREAD BREAKS
① Spring Type
① The upper and the lower threads are detected by two separate devices. The machine stops automatically when the
upper thread breaks or the lower thread is out of the needle (lower thread detector is optional for all machines
except for single-head).
② Wheel Type
② Wheel and wheel sensor board are installed in the tension adjustment board to detect both the upper and the lower
threads. The machine stops automatically when the upper thread breaks or the lower thread is out of the needle.
13) AUTOMATIC RETURN TO STOP POINT IN UNEXPECTED BLACKOUT
When the power fails unexpectedly, the frame moves back to the exact point where the stitching stopped. This helps
reduce the number of defects.
14) 3.5”FLOPPY DRIVE (EMBEDDED)
A 3.5”floppy drive is embedded in the operation panel for you to read or store designs. Both 2DD and 2HD disks
can be used.
15) EDITING
You can delete, change, or insert stitch data and function codes (jump, finish, trimming).
16) AUTOMATIC STORAGE OF DESIGN SET-UP
The machine automatically stores “basic set-up”for each design and calls the set-ups when a specific design is
called. This reduces your preparation time.
17) INDIVIDUAL HEAD OPERATION
You can work on the specific head with a broken thread.
18) MACHINE STOPPAGE
The screen will indicate why the machine has stopped.
19) RPM
The screen indicates rpm.
20) FRAME SPEED SET-UP
You can adjust the frame speed to high, medium, or low.
21) UNUSED MEMORY
The screen indicates the memory available for use.
22) TAPE CODE COMPATIBILITY
2-binary and 3-binary tape codes can be edited.
23) 800
*
600 COLOR LCD MONITOR (OPTIONAL)
You can install a 800
*
600 color LCD monitor onto your operation panel for easier reading of data.
24) CODES FROM OTHER BRANDS
The machine can automatically read designs of various formats stored in the floppy disk. These formats include
SST/ DST, DSB, DSZ/ TAP/ FMC, FDR/ ZSK/ 10O/ EXP.
To Next Page
Loading...
Need help?
General
