7-41
⑪ MIN SPEED
This sets the minimum machine speed. The default is 300 rpm and the range is from 300 rpm to the maximum
speed limit in the increments of 10 rpm.
⑫ JUMP SPEED
This sets the speed limit for jump stitching (frame moves without sewing). The default is 750 rpm and the range
is from the maximum to the minimum speed limit in the increments of 10rpm.
⑬ INC SPEED
This sets the speed of inching (low-speed stitching) at the start of the embroidery. The default varies by the
machine type and the range is 50-200 rpm in the increments of 10 rpm.
(Inching speed)
(Minimum speed limit)
⑭ SLOW SPEED
You can work at a slow speed on a particular part of a design by selecting when the machine stops during
the embroidery. The range is from the maximum to minimum speed limit in the increments of 10 rpm.
⑮ BOTTOM STOP
This sets the needle bar to stop at the lower dead stop when the embroidery is finished. The default is “NO”and
you can input “1”to set it to “YES.”
⒃ POWER ORG
This selects the frame to move back to the start position when the power comes on.
The default is “NO(0)” and you can set “YES(1)”.
⒔ FRAME SPEED
This sets the speed of the frame movement such as automatic return to start position or offset movement. The
default is “LOW (0)”and you can select “HIGH (1)”for high speed.
⒕ SPEED DATA
This decreases the overall embroidery speed if the work material becomes too heavy for normal operation. The
default is “HIGH (1)”and you can select “LOW (0)”to slow down the speed by 30-50 rpm.
(Speed set-up data)
(Speed of frame movement)
(Back to start position when power comes on)
(Lowest point stop of needle after work completion)
CAUTION
[CAUTION]
Do NOT attempt to manually change the needle bar when it bottom stopped.
series
series
series
100
100
100
180
100
100
100
100
100
Default Inching Speed
Machine Type
Contents
W
T
U
SWF/ –W1201
SWF/
–WE1204
SWF/
–WE1206 WF912
SWF/
–T1201 T1501
SWF/
–UK1202 UK1502
SWF/
–UK1204 UK1504
SWF/
–UK1206 UK1506
SWF/
–UH1206 UH1506 UH1508
SWF/
–UI1212
Jump speed higher than 750 rpm may cause needle break or mechanical problems in the
needle bar.
To Next Page
Loading...
Need help?
General
