Questions? Call or Text +1-801-658-0015 • 1
e Micro Welder Experts
Welder Setup & Assembly
What is in the Box
(1) Orion mPulse Welder/Power Supply and Stylus Hand Piece
(1) Orion mPulse Welder Power Cord (2 pieces)
(2) Alligator Clips
(1) Shielding Gas Hose
(1) Electrode Vial (5 1.0 mm Electrodes)
(1) Fiberglass Brush
If You Purchased the Darkening Lens System:
(1) Darkening Lens System (lens and stand) with attached RJ45 Cable
If You Purchased the Microscope System:
(1) Orion Microscope Arm
(1) Microscope Arm Table Mount
(1) Microscope Arm Support Bar
How to Connect the Basic Cables
The Orion mPulse cable connections vary. If you purchased the darkening lens or the microscope, cabling
needs change slightly. The darkening lens or microscope will automatically darken when the weld takes place,
which allows the operator to have a view of the work piece and remain protected from the ash during the weld-
ing process. Reference Figure 2.1 on the next page and follow these instructions for easy setup:
• Remove the welder and Darkening Lens System from the box and place them on a at work space.
• Plug the female end of the power cable into the AC Power port (D) on the back of the power supply.
Then connect the male end into an AC power supply. The Orion mPulse has an internal switching
power supply that can accept both 120 and 240VAC.
To Next Page
Loading...
