PART NO. 690809 REV: A 35
Check for chafing, scraping or other signs of external damage
Comments____________________________________
Fasteners: Check for wear or corrosion and ensure all bolts are tight (may need to remove marine growth to prop-
erly inspect)
Float tubes (while lift is in down position)
Float bands
Float brackets
End plates
Union Plates
Comments____________________________________
Hoses – 5 Minutes
Follow hoses from Powerpack to cylinders
Remove excessive marine growth (more than 1” in diameter)
Hoses are not being pinched or chaffed by pier, boats, cables, lift, etc
Hoses are not being kinked
Hose ends and junctions have protective tape in good condition
No leaks present (fluid is pinkish/red in color)
Comments____________________________________
Cylinders – 3 minutes
Cylinder coating is in good condition with no bare spots or chaffing
Verify retaining rings are present and on bottom of cylinder pins
Verify retaining ring present on top of cylinder pins
No fluid leaks from fittings or top of cylinder
Comments____________________________________
Frame – 5 minutes
All welds in tact, and without propagating cracks
No sign of corrosion or wear
Inspect pivot points for cylinders and castings for wear
Bunks securely attached to bunk brackets and frame
Check that all nuts are tight
Bunk rubber in good condition
Comments____________________________________
Inspection Checklists
To Next Page
Loading...
