Features and How to set parameters
Suntech International Ltd.
Disclaimer
We, at Suntech, announce that this document and all other related products (i.e. device, firmware, and software)
have been developed by the company, Suntech International Ltd., which is hereinafter referred to as “Suntech”.
The information in this manual is believed to be accurate and reliable at the time of releasing. We, at Suntech, also
assume no responsibility for any damage or loss resulting from the use of this manual, and expressly disclaim any
liability or damages for loss of data, loss of use, and property damage of any kind, direct, incidental or
consequential, in regard to or arising out of the performance or form of the materials presented herein or in any
software program(s) that may accompany this document. When this document is released, it is most compatible
with a specified firmware version. Now that the functionalities of the devices are being developed and improved
continuously from time to time by Suntech, any alteration on the protocol, the firmware functions, the hardware
specifications of the product is subject to change without prior notice.
Copyright
We, at Suntech, notify that Suntech holds all parts of intellectual rights applicable in the copyright laws in all the
countries. The information contained in this document cannot be reproduced in any form without prior written
consent made by Suntech. Any software programs that might accompany this document can be used only in
accordance with any license agreement(s) between the purchaser and Suntech.
Warning
Our customers are required to be aware that connecting the wire inputs can be hazardous to both of the installer
and your vehicle’s electrical system(s) if not done by an experienced installer. This document assumes you are
aware of the inherent dangers of working in installing the device on the vehicle(s) and the machinery.
Document Amendments
Please be advised that, for the firmware version column with specific firmware number, any modification(s) on the
comments column should be done on this corresponding firmware version (and the versions thereafter). Please
make sure you upgrade the firmware to the specified version before applying any changes made in this protocol.
To Next Page
