SunTech ST4310 - Emergency Acknowledgement Command; Enable Output 1 Command

ST4310 User Manual
22
RPT;60;180;120;60;3;0;0;;;;
EVT;1;60;0;3;2;2;30;20;20;1;1;1;0;0;0;0;0;0;0;0;0;0;0;0;
LTE-M1;0;;;;;0;;;;;;;;
SVC;1;120;0;0;0;0;1;1;1;0;0;0;0;
ADP;U;T;2;9000;0;0;0;0;0;0;
DEV;0;0;0;0;0;0;0;0
<notes>
** This command can be applied from software version 22.
** DEV filed informs current status of device as below.
OUT1
0 = Disable
1 = Enable
OUT2
0 = Disable
1 = Enable
PWR_DN
0 = Normal
1 = Sleep
2 = Deep sleep
BAT_CON
0 = Backup battery is
disconnected.
1 = Backup battery is connected.
TRACKING
0 = Stop Tracking
1 = Start Tracking
Anti-Theft
0 = Disable
1 = Enable
Reserved Reserved
4-11-4. ACK of Emergency
● Definition : Stop emergency report.
Field Definitions Unit Remark
CMD_ID “AckEmerg” Acknowledgement of emergency report.
The device will stop emergency reports if it is in emergency
state.
<example>
[command] ST4310CMD;850000;02;AckEmerg
[response] ST4310CMD;Res;850000;010;AckEmerg
4-11-5. Enable1